Before using Clean&Charge
First charge:
For the first charge of the shaver, connect the power supply cord set directly to the shaver, charge it for 4 hours and shave at least once.
Only then can the shaver be cleaned or recharged in the Clean&Charge.
If the rechargeable batteries are discharged, select the combined «clean» + «charge» programme rather than the «clean» programme alone.
Installing the cartridge
Press the lift button (12) to open the housing.
Hold the cartridge down on a flat, stable surface
(e.g. table). Carefully remove the lid from the cartridge. Slide the cartridge into the base as far as it will go.
Slowly close the housing by pushing it down until it locks.
Replacing the cartridge
After having pressed the lift button to open the housing, wait for a few seconds before removing the used car- tridge.
Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.
Operating your Clean&Charge
•Use the power supply cord set from your shaver and plug it into the Clean&Charge and then into a main outlet.
Open the contact bow (13) by pressing the release button (14). After shaving, switch the shaver off and place it upside down into the Clean&Charge. The pivoting head must not be locked (switch «head lock» position down)
•Select the operation mode by toggling with the mode selector (15):
clean (about 15 min)
clean + charge (about 75 min) charge (about 60 min)
The corresponding lights will come on.
7570
2 1
new
old new
5441
5441
on/off 
clean charge
11