Braun 5441 manual Select

5441

select

5441

select

•Slide down the contact bow to connect the shaver and to start the selected program.

If no program is selected, the default function «clean» will be started.

•Do not interrupt a running program, as it leaves the shaver wet and not fit for use. If interruption is need- ed nonetheless, press the release button.

•After a program has finished, the corresponding light will go out. If later on, and when in charging mode, the charging light of the shaver comes on again. This indicates that the shaver is being recharged to maintain its full capacity. Prior to the next shave, press the release button to release the shaver.

•When the «cartridge» light starts flashing, the remaining fluid in the cartridge is sufficient for ap- proximately 5 more cleaning cycles. After these

5 cycles, the cleaning performance will be reduced and the car-tridge has to be replaced.

•When the «cartridge» light illuminates constantly, the cleaning function is locked and a new cartridge has to be installed. Only then, the next cleaning cycle can be started.

•A cleaning cartridge should be sufficient for about 30 cleaning cycles. With daily use, the cleaning car- tridge should be replaced approx. every 4 weeks.

•The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks.

Clean the housing from time to time with a damp cloth, especially the opening where the shaver rests.

Accessories

Available at your dealer or Braun Service Centers: Refill cartridge (double pack) CCR 2, (#5331)

Subject to change without notice.

12