■Assigning the IP address manually
Follow the procedure below to register the network information manually.
Note
Before setting the network information, check that this unit is connected properly to the network. If the disconnected icon (page 10) is displayed on the top right of the display, check the LAN cable connection and the condition of the network to which the LAN cable is connected.
y
The factory settings of the network information are as follows.
–IP address: 192.168.100.200
–Subnet mask: 255.255.255.0
–Default gateway: 0.0.0.0
Numeric keys
|
|
| LAN | |
1 | 2 | 3 |
| |
4 | 5 | 6 | OUT | |
AUDIO | ||||
7 | 8 | 9 | ||
| ||||
|
|
| IN | |
| 0 |
|
| |
| MIC MUTE | VOL | IN 12V | |
|
|
| DC |
/ 
/ 
1 Press 
repeatedly until the initial display appears.
“???.???.???.???” is displayed when the DHCP server does not exist in the network, and the IP address obtained from the DHCP server is displayed when it exists.
IP: ???.???.???.???
Menu 
:Address
Preparation Procedure
2 Press .
The menu screen appears.
Menu
1. Settings
2.Call History
3.Online
3 Press or | to select “1. Settings”, and |
then press | . |
The “Settings” menu appears.
Settings
1. Network Settings
2.Sound Settings
3.General Settings
4 Press 
or to select “1. Network Settings”,
and then press 
.
The “Network Settings” menu appears.
Network Settings
1. IP Address
2.Subnet Mask
3.Default Gateway
PREPARATION
English
11