■Configuring the DHCP server settings
Select “Enable” to assign the network information of this unit using the DHCP server or “Disable” to assign the network information manually. The default setting is “Enable”.
Using the keys on this unit
In the initial display, select “Menu” → “Settings” → “Network Settings” → “DHCP”.
Using the web menu
In the web menu, select “DHCP”.
■Configuring the connection mode
You can select the mode used in connections involving multiple locations. The default setting is “Mesh”.
•Mesh: This unit establishes a separate session with each of the locations involved in the conference call.
This mode is indicated by 
on the display.
•Cascade Server: This unit functions as the server in the cascade connection inside the location it is installed. With respect to other locations, it functions the same as the “Mesh” mode. This mode is indicated
by | on the display. |
•Cascade Client: This unit functions as a client in the cascade connection inside the location it is installed.
This mode is indicated by | on the display. |
Note
The mesh connection is available only when “G.711 Extension” or “G.711
y
For details on the cascade connection, see “Hierarchical Connection of Multiple PJP Units (Cascade Connection)” (page 40).
Using the keys on this unit
In the initial display, select “Menu” → “Settings” → “Network Settings” → “Connection Mode”.
Using the web menu
In the web menu, select “Connection Mode”.
Setting Menu List
■Configuring the NAT traversal setting
When this unit exists in a network that uses the NAT, select “Enable” to connect this unit to a PJP unit on an external network. The default setting is “Disable.”
Notes
•Even when “Enable” is selected, connection to a PJP unit on an external network may be impossible depending on the network settings.
•When the external network has a SIP server, you cannot specify the SIP address to make a communication between the PJP units in the same segment.
Using the keys on this unit
In the initial display, select “Menu” → “Settings” → “Network Settings” → “NAT Traversal”.
Using the web menu
In the web menu, select “NAT Traversal”.
■Configuring the SIP server setting
Select “Enable” to use the SIP server for the call. The default setting is “Disable.” To use the SIP server, you need to register the SIP server name and password using the web menu. See page 35 for details.
Notes
•Even if you select “Enable”, the SIP server is not available for a call unless the SIP server name and password are registered in the web menu.
•To connect a call using a SIP server, it is required to register the SIP address of this unit. See page 35 for details.
Using the keys on this unit
In the initial display, select “Menu” → “Settings” → “Network Settings” → “SIP Server”.
Using the web menu
In the web menu, select “SIP Server”.
■Registering the unit name 
You can register the name of this unit by entering a desired character string.
Using the web menu
In the web menu, select “Unit ID”.
CONFIGURATIONS
English
27