Samsung Version 2.1 manual Status View of Ports in Use

Page 22

OfficeServ Link Version 2.1 User GuideLink Settings

--------------------------------------------------------------------------------------------------------------------------------------------------------------------

Communication Environment Setup for user connection in standby

As soon as connections have been successfully completed with the telephone system, the Link starts a process in order to perform the service needed to receive requests from users. In the LAN-based TCP/IP case this listening port is set to 6000 by default. Usually this will not need to be changed, but port numbers 1024 or higher can be used if necessary. Values of 0 ~ 1023 have been already built in the Link.

A port currently being used for another service by the computer cannot be specified. There is a command for you to check which TCP/IP port numbers are currently used. Use the command at the command prompt of Windows as follows:

c:\>Netstat -a -e -n -p TCP

	Figure 3.5 Status View of Ports in Use

Note	The setting of communication environment can be done only in the offline status between Link
	and telephone system. Online state (Disabled) does not allow you to activate this function button.

Page 22

© SAMSUNG Electronics Co., Ltd

Image 22

Contents User Guide OfficeServ Link About This Manual ConventionsPage Table of contents OfficeServ Link Version 2.1 User Guide Introduction Overview of OfficeServ LinkPage Computer System Requirements Installation of LinkPreparation for installing Link DCS Key Telephone RequirementsConfiguration Environment LinkSystem Administration Requirements InstallationPage Page Page Page Installing the Link License Post InstallationChecking the registered program group OfficeServ Link Settings Executing OfficeServ LinkConfiguration of Link Main Window Description of Link Main WindowLink Status bar information Status BarCommunication Environment Setup Connection mode to telephone systemCommunication Environment Setup for TCP/IP connections IDCS 500/OfficrServ Serial, 19200 BPSStatus View of Ports in Use Example of Environment Setup Example of TCP/IP connectionsNormal option Option SettingsRestriction for the currently connected users in number Message Auto Clear Option General message monitoring option settingsMessage Monitoring and Saving Option Automatic connection to PBX system at Link startupSMDR/ UCD message monitoring option settings Password Protection OptionOfficeServ Call+ Function Support Option Smdr / UCD Message Exteranl Send OptionsLink State Message Display Option Recovery Try Time Period Option Switch Link Recovery Try Count OptionLink Display Language Option Page Page Connecting to a telephone system Using LinkCheck the configuration of the Phone System Telephone settings for a serial Link connectionOfficeServ Link Version 2.1 User GuideMessage Monitoring Connection state of Link is indicated as , and the AVI 1st recovery try failed and wait 1 minute Disconnecting to the PBX system and user Selection of Disconnect buttonViewing Link state in Default mode Link Operating State ViewCase that a user is currently connected User-connected LinkMessage Monitoring Running the Switch Message Monitor SCMonitor.exeCall processing message monitoring program Environment Setup Environment Setup of Switch Message Monitor ProgramMain window of Switch Message Monitor Smdr / UCD Message Monitoring Program Click on the Stop Monitoring button to stop monitoringRunning the Smdr / UCD Message Monitor SUMonitor.exe Executing the Smdr / UCD Message MonitorConfiguration of window is as follows Main window of Smdr / UCD Message Monitor Message MonitoringOfficeServ Link Version 2.1 User Guide Installing Monitoring Program on other Computer Page Page License Registration Running the License ToolsInstalling the License Paste the valid license keyLink Shutdown Check How to check the License Status Page Samsung OfficeServ Link