Appendix J
In case of difficulty
| • Check to make sure that each telephone set |
| has a unique extension number. If the sets |
| receive AC power at the same time, either |
| at initial installation or after a power failure, the |
| extension numbers may be the same. Refer |
| to the EXTENSION NUMBER section of the |
| installation guide, (page 32). |
|
|
LOW BATT is displayed on | • No spare battery is installed or the spare battery |
screen. | needs to be replaced. |
| • Remove and |
|
|
The telephone does not | • Make sure the ringer is on (page 14). |
ring when there is an | • Make sure the telephone line cord(s) and the |
incoming call. | power adapter are plugged in properly (See the |
| Installation Guide). |
| • There may be too many extension telephones on |
| the telephone line to allow all of them to ring |
| simultaneously. Try unplugging one phone at a |
| time until the phones start ringing. |
| • Test a working telephone at the same |
| telephone jack. If another telephone has |
| the same problem, the problem is in the |
| telephone jack. Contact your local telephone |
| company (charges may apply). |
| • The telephone line cord might be malfunctioning. |
| Try installing a new telephone line cord. |
| • Make sure the Do Not Disturb feature is not activated |
| (page 15). |
| • Make sure the ringer delay time (page 34 of the |
| installation guide) is not longer than the answer |
| delay time of the answering system (page 58 of the |
| installation guide). This would cause the answering |
| system to answer the call before the phone rings. |
| • If you are on a call, there will be a beep to alert |
| you of incoming calls on the other lines. |
| • Make sure that the LINE GROUP assignment is |
| correct. See page 43 of the installation guide. |
Cannot join a conversation • The call privacy feature prevents another set on
in progress.the system from interrupting a conversation. Make sure you press the LINE button to release privacy. (See Call privacy on page 21.)
103