Ryobi p745 manuel dutilisation Charging a HOT Battery Pack, Charging a Cold Battery Pack

Page 13

OPERATION

Do not place the charger in an area of extreme heat or cold. It will work best at normal room temperature.

NOTE: The charger and battery pack should be placed in a location where the temperature is more than 50°F but less than 96°F.

The battery pack may become slightly warm to the touch while charging. This is normal and does not indicate a problem.

After charging is complete, the green LED will remain on until the battery pack is removed from the radio/charger or charger is disconnected from the power supply.

NOTE: Always remove the battery pack from the radio/ charger before unplugging the unit from a power source, or before plugging the unit into a power source.

To remove the battery pack from the charger, depress latches and pull up on the battery pack.

When the battery pack is fully charged, remove it from the charger.

CHARGING A HOT BATTERY PACK

When using a tool continuously, the battery pack may become hot. A hot battery pack may be placed directly onto the charger port but charging will not begin until the battery temperature cools to within acceptable temperature range. When a hot battery pack is placed on the charger, the red LED will begin flashing and the green LED will be off. When the battery pack cools to approximately 120°F (40°C), the charger will automatically begin charging.

CHARGING A COLD BATTERY PACK

A cold battery pack may be placed directly onto the charger port but charging will not begin until the battery temperature warms to within acceptable temperature range. When a cold battery pack is placed on the charger, the red LED will begin flashing and the green LED will be off. When the battery pack warms to approximately 32°F (0°C), the charger will automatically begin charging.

LED FUNCTIONS

MODE

BATTERY PACK

GREEN

LED

RE15D

LED

ACTION

Power On

Testing

Defective

Without

OFF

 

Ready to charge battery pack.

battery pack

 

 

ON

 

 

 

 

Hot battery pack

 

 

When battery pack reaches cooled temperature, charger

 

 

begins fast charge mode.

 

 

 

 

 

 

 

Cold battery pack

OFF

 

When battery pack reaches warmed temperature, char-

 

ger begins fast charge mode.

 

 

 

 

 

Flashing

 

Deeply discharged

 

Charger pre-charges battery until normal voltage is

 

 

 

 

reached, then begins fast charge mode.

 

 

 

Defective

OFF

 

Battery pack or charger is defective.

 

 

Fading

 

 

 

 

 

If defective, try to repeat the conditions a second time by removing and reinstalling the battery pack. If the LED status repeats a second time, try charging a different battery.

If a different battery charges normally, dispose of the defective pack (see Maintenance section).

If a different battery also indicates “Defective,” the charger may be defective.

Charging

Charged

Energy Save Mode

Fast charging

 

 

Battery is being charged.

 

Flashing

ON

 

Battery full

 

OFF

Fast charging is complete; charger maintains charge

 

mode.

 

ON

 

 

 

 

Battery full /

 

OFF

Battery pack is fully charged and charger is in

Energy Save mode

 

Energy Save mode.

 

 

 

Fading

 

 

 

 

 

 

13 - English

Image 13
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction WarrantyElectrical Safety General Safety RulesPersonal Safety Product USE and CareService Specific Safety RulesSafety Rules for Charger Important Safety InstructionsCalifornia Proposition SymbolsOther reproductive harm. Wash hands after handling Electrical Cord Length Wire Size A.W.GDouble Insulation Electrical ConnectionFeatures FCC Compliance AssemblyUnpacking Packing ListTo Install / Remove AAA Batteries Included Battery Protection FeaturesTo INSTALL/REMOVE Battery Pack not Included OperationMode Selection Adjusting the VolumeManual Tuning Storing a Preset in MemoryUsing MP3 and CD Players Setting the ClockCharging Charging a Cold Battery Pack Charging a HOT Battery PackGeneral Maintenance MaintenanceBattery Pack Removal and Preparation for Recycling Replacing the AntennaTable DES Matières Règles DE Sécurité Générales Dépannage Règles DE Sécurité ParticulièresAvertissement Règles DE Sécurité Pour LE ChargeurAVERTISSEMENT  SymbolesNOM Désignation / Explication Proposition 65 DE LA Californie AvertissementDouble Isolation Caractéristiques ÉlectriquesConnexions Électriques Cordons ProlongateursCaractéristiques Déballage AssemblageListe DE Contrôle D’EXPÉDITION RETRAIT/INSTALLATION DUE BLOC-PILES NON Fourni Installation ET Remplacement DES DES Piles DE AAA ComprisesUtilisation Caractéristiques DE Protection DES PilesSélection DU Mode Réglage DU VolumeConseils Généraux D’UTILISATION ACL RétroéclairéPour syntoniser les stations préréglées FM ou AM Réglage DE L’HORLOGERéglage de l’heure Pour visualiser l’heureSignaux DES Témoins DEL Entretien Remplacement DE L’ANTENNECharge D’UN Bloc DE Piles Chaud Charge D’UN Bloc DE Piles FroidIntroducción Índice DE ContenidoGarantía 10-14¡ADVERTENCIA Reglas DE Seguridad GeneralesSeguridad Eléctrica Seguridad PersonalReglas DE Seguridad Específicas Instrucciones DE Seguridad GeneralesServicio LEA Y Comprenda Todas LAS INSTRUCCIONES. El Reglas DE Seguridad Para EL Empleo DEL CargadorPeligro SímbolosAdvertencia PrecauciónDoble Aislamiento Aspectos EléctricosConexión Eléctrica Cordones DE ExtensiónCaracterísticas Cumplimiento DE LAS Normas DE LA FCC ArmadoDesempaquetado Lista DE EmpaquetadoUsos FuncionamientoCaracterísticas DE Protección DE LAS Baterías Para Instalar Y Quitar Baterías AAA IncluidaCORDÓN, Sólo CORR. ALT Ajuste DEL VolumenConsejos DE USO General Pantalla DE Cristal LíquidoUSO DE Reproductores DE MP3 Y Reproductores DE CD Tajuste DEL RelojCarga Funcionamiento DE LOS Diodos Luminiscentes Cómo Cargar LA Batería Cuando Está Caliente MantenimientoCómo Cargar LA Batería Cuando Está Fría Mantenimiento GeneralCâble NON COMPRIS, Cable no Incluido Cable not IncludedTUNE/SEEK/DOWN syntonisation/chercher/bas, recorrer/abajo Charger LED Status P745 P745