ACCESSORIES | ||
|
|
|
INNERSHIELD (FCAW)
CONVERSION
Several changes are needed to convert the unit for operation with the Innershield (FCAW) process:
1.Change the output polarity to
2.Install proper drive roll for the wire size selected. See “Changing Drive Roll” in Maintenance section for details.
3.Install the proper gun liner1 and tip for the wire size selected. See “Component Replacement” in Maintenance section for details.
4.Remove gas nozzle (if installed) and install the gasless nozzle. To remove, simply unscrew.
5.Load wire into machine and thread into gun and cable per “Welding Wire Loading” section.
1The factory installed gun liner will feed up to .035 (0.9mm) wire.
REPLACEMENT PARTS
Complete Gun and Cable Assembly
Contact Tip .025” (0.6 mm)
Contact Tip .030” (0.8 mm)
Contact Tip .035” (0.9 mm)
Contact
Contact
Contact
Liner .025
Gas Diffuser
Gas Nozzle
Gas
Gas
Gas
Spot Welding Nozzle
Gasless Nozzle (Innershield Only)