DeWalt DW9106 instruction manual Read ALL Instructions, Bpm

Page 5

English

tools with large battery packs will stand upright on the battery pack but may be easily knocked over.

CAUTION: DO NOT TOUCH ANY METAL PARTS OF THE TOOL when drilling or driving into walls, floors or wherever live electrical wires may be encountered! Hold the tool only by insulated grasping surfaces to prevent electric shock if you drill or drive into a live wire.

CAUTION: Wear appropriate hearing protection during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.

• The label on your tool may include the following symbols.

V

volts

A

amperes

Hz

hertz

W

watts

min

minutes

no

alternating current

 

 

....direct current

no load speed

 

 

 

 

Class II Construction

 

 

 

 

earthing terminal

 

 

 

 

 

 

........

 

 

 

..........

 

 

 

 

 

 

........

safety alert symbol

.../min....

revolutions per minute

BPM

................beats per minute

 

Important Safety Instructions for Battery Packs

Your tool uses either a 12, 14.4 or 18 Volt DEWALT battery pack. When ordering replacement battery packs, be sure to include catalog num- ber and voltage: Extended Run-Time battery packs deliver 25% more run-time than standard battery packs.

NOTE: Your tool will accept either standard or Extended Run Time battery packs. However, be sure to select proper voltage.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.

READ ALL INSTRUCTIONS

Do not incinerate the battery pack even if it is severely dam- aged or is completely worn out. The battery pack can explode in a fire.

A small leakage of liquid from the battery pack cells may occur under extreme usage or temperature conditions. This does not indicate a failure. However, if the outer seal is broken and this leakage gets on your skin:

a.Wash quickly with soap and water.

b.Neutralize with a mild acid such as lemon juice or vinegar.

c.If battery liquid gets into your eyes, flush them with clean water for a minimum of 10 minutes and seek immediate medical attention. (Medical note: The liquid is 25-35% solution of potas- sium hydroxide.)

Do not carry extra battery packs in aprons, pockets, or tool boxes along with other metal objects. Battery pack could be short circuited causing damage to the battery pack and possibly causing severe burns or fire.

Charge the battery packs only in DEWALT chargers.

DO NOT splash or immerse in water or other liquids.

Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 105°F (such as outside sheds or metal buildings in summer).

DANGER: Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert into charg- er. Electric shock or electrocution may result. Damaged battery packs should be returned to service center for recycling.

NOTE: Battery storage and carrying caps are provided for use whenever the battery is out of the tool or charg- er. Remove cap before placing battery in charger or tool.

WARNING: Do not store or carry battery so that metal objects can contact exposed battery terminals. For example, do not place battery in aprons, pockets,

tool boxes, product kit boxes, drawers, etc. with loose nails, screws, keys, etc. without battery cap. Without cap in place, battery could short circuit causing fire or burns or damage to battery.

CAUTION: Battery pack must be securely attached to tool. If bat- tery pack is detached, personal injury may result.

2

Image 5
Contents Ewalt Battery and Charger Systems Guide Dutilisation Manual DE Instrucciones Electrical Safety General Safety Rules For All Battery Operated ToolsPersonal Safety Work AreaService Specific Safety RulesBPM Read ALL InstructionsRbrc Seal Important Safety Instructions for Battery ChargersUsing Automatic TUNE-UP Mode Battery PerformanceUsing the Manual TUNE-UP Mode For Future USEIndicator Light Operation Charging ProcedureCharge Indicators ChargersOperation Installing and Removing the Battery PackVariable Speed Switch Fig Forward/Reverse Control Button Fig Torque Adjustment Collar FigThree Speed Gearing Fig Keyless Single Sleeve Chuck FigOperation as a Drill Side HandleDrilling in Wood Drilling in MetalMaintenance DAY no Risk Satisfaction Guarantee Full WarrantyConserver CES Directives Règles générales de sécurité concernant les outils à pilesEntretien Règles de sécurité specifiqueLire Toutes LES Consignes Importantes consignes de sécurité concernant les bloc-pilesImportantes consignes de sécurité concernant les chargeurs Sceau RbrcmcCalibre AWG Rendement des blocs-pilesUtilisation DU Mode TUNE-UPMCMANUEL Utilisation DU Mode TUNE-UPMCAUTOMATIQUEConserver CES Consignes Pour Utilisation Ultérieure ChargeursRemarques importantes sur la charge Fonctionnement du voyantIndicateurs de charge Montage et démontage du bloc-piles Commande de variation de vitesse FigFonctionnement Bouton à trois vitesses d’engrenage fig Bouton de commande marche avant ou marche arrière figCollier de réglage de couple fig Mandrin à manchon unique sans clé fig Mode perceusePoignée latérale PerçageEntretien Garantie complète AccessoiresRéparations Área DE Trabajo Guarde Estas InstruccionesSeguridad Eléctrica Seguridad PersonalServicio Reglas específicas de seguridadGolpes por minuto LEA Todas LAS InstruccionesEl sello Rbrcmc Utilizacion DEL Modo Tune Upmc Automatico Rendimiento de la bateríaCargadores Guarde Estas Instrucciones Para SU Futura UtilizaciónProcedimiento de carga Operación de la luz indicadoraIndicadores de carga Linea DE Alimentacion ProblematicaNotas importantes sobre la carga Retardo POR Bateria CALIENTE/FRIAInstalación y remoción de la batería OperaciónInterruptor de velocidad variable Fig Botón de control de marcha adelante/reversa FigEngranaje de tres velocidades Fig Ajuste del collar de torsión de apriete FigPara funcionar como taladro Mango lateralTaladrado en madera TaladradoMantenimiento Póliza de Garantía ReparacionesExcepciones Garantía CompletaPara Otras Localidades Llame AL 326
Related manuals
Manual 36 pages 30.71 Kb