Panasonic Complete Guide to the EY7410 Charger and Manual

Page 5

Symbol

Meaning

 

 

V

Volts

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Direct current

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

n0

No load speed

 

 

 

 

 

 

 

 

…/min

Revolutions or reciprocations per

minutes

 

 

 

 

 

 

 

 

Ah

Electrical capacity of battery pack

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Rotation only

 

 

 

 

 

 

 

 

WARNING!

Some dust created by power sanding, saw­ ing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

Lead from lead-based paints

Crystalline silica from bricks and cement and other masonry products

Arsenic and chromium from chemical­ ly-treated lumber.

To reduce your exposure to these chemi­ cals: work in a well ventilated area, and work with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.

III. FOR BATTERY CHAR­

GER & BATTERY PACK

Important Safety Instructions

1)SAVE THESE INSTRUCTIONS -This manual contains important safety and operating instructions for battery charger EY0L10.

2)Before using battery charger, read all instructions and cautionary markings on battery charger, battery pack, and product using battery pack.

3)CAUTION -To reduce the risk of injury, charge only Panasonic Battery Pack as shown in last page.

Other types of batteries may burst causing personal injury and damage.

4)Do not expose charger and battery pack to rain or snow.

5)To reduce risk of damaging the electric plug and cord, pull by plug rather than cord when disconnecting charger.

6)Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

7)An extension cord should not be used unless absolutely necessary.

Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure that:

a.pins on plug of extension cord are the same number, size and shape as those of plug on charger.

b.extension cord is properly wired and in good electrical condition.

c.wire size is large enough for ampere rating of charger as specified below.

RECOMMENDED MINIMUM AWG SIZE OF

EXTENSION CORDS FOR

BATTERY CHARGERS

AC Input Rating.

Amperes

AWG Size of Cord

Equal to or

But less

Length of Cord,

 

greater than

than

Feet

 

 

 

 

 

25

50

100 150

0

2

18

18

18

16

8)Do not operate charger with damaged cord or plug-replace them immediately.

9)Do not operate charger if it has received a sharp blow, been dropped, or other­ wise damaged in any way; take it to a qualified service personnel.

10)Do not disassemble charger; take it to a qualified service personnel when service or repair is required. Incorrect reassembly may result in a risk of ele­ ctric shock or fire.

11)To reduce the risk of electric shock, un- plug charger from outlet before attempting any maintenance or cleaning.

12)The charger and battery pack are spe­ cifically designed to work together. Do not attempt to charge any other cordless tool or battery pack with this charger.

13)Do not attempt to charge the battery pack with any other charger.

14)Do not attempt to disassemble the bat­ tery pack housing.

15)Do not store the tool and battery pack in locations where the temperature may reach or exceed 50°C (122°F) (such as a metal tool shed, or a car in the

- -

Image 5
Contents Model No EY7410 Index/Index/Indice Electrical Safety Work Area SafetyPersonal Safety Power Tool Use and CareII. Specific SAFE­ TY Rules Battery Tool Use and CareService Symbol Meaning Important Safety Instructions Hexagonal Bit Chuck IV. Assembly Operation Clutch Handle Clutch Torque Setting  Using the LED Light  Battery Low Warning Lamp Main Switch Lock  Main Switch ON/OFF Battery Pack EY9L10  Speed Selector SwitchBattery Pack Life Li­ion Battery pack EY9L10Battery Recycling Common Cautions for the Li­ ion/Ni­Cd Battery PackDuring charging, the charging lamp will be lit Ni-Cd Battery PackVI. Accessories MaintenanceMain Unit VII. SpecificationsSécurité de la zone de travail Rite GeneralesSécurité électrique Sécurité personnelleMaintenez les outils de coupe affûtés et propres Utilisation et soins de l’outil méca­ niqueUtilisation et soins de la batterie de l’outil Particulieres Symbole SignificationInstructions de sécurité impor­ tantes RéparationNorme d’entrée Ampères  Mandrin de mèche hexagonal IV. Assemblage Utilisation de la lumière DEL  Témoin d’avertissement de batterie basse Interrupteur principal ON/ OFF  Fonction de verrouillage de la mèche Commutateur du sélecteur de vitesse  Verrou de l’interrupteur prin­ cipalBatterie autonome Li­ion EY9L10 Batterie autonome Li­ionLongévité des batteries autonomes Recyclage de la batterie autonomeBatterie autonome Ni-Cd Par exemple, à la suite d’un long tra- vail de perçage EntretienVII. Caracteristiques Techniques VI. AccessoiresSeguridad del lugar de trabajo DAD GeneralesSeguridad eléctrica Seguridad personalMantenga las herramientas de corte afiladas y limpias Uso y cuidados de herramientas eléctricasUso y cuidado de la herramienta a batería III. Para EL CARGA­ DAD EspecíficasInstrucciones de seguridad im­ portantes ServicioIgual o mayor Pero me  Mango de embrague Ajuste de torsión del em­ brague IV. Montaje Y Funcionamiento Portador de broca hexagonal  Utilización de la luz LED  Luz de advertencia de batería baja Interruptor principal ON/OFF  Función de bloqueo de broca Bloqueo del interruptor prin­ cipal  Batería EY9L10Vida útil de la batería Batería de Li­ión EY9L10Reciclado de la batería Precauciones comunes para las baterías Li­ión/Ni­CdBatería Ni-Cd Indicación DE LA Lámpara MantenimientoVII. Especificaciones VI. AccesoriosMemo Panasonic Consumer Electronics Company