Panasonic EY7410  Bit-locking Function,  Main Switch ON/OFF,  Main Switch Lock

has a negligible effect on the operational capacity of the drill.

●The LED is incapable of lighting the tip of the bit when the drill is used in the straight configuration.

Bit-locking Function

With the switch at off and the bit lock­ ed in place, the tool can be used as a manual screw-driver - up to 14.7 N·m (150 kgf-cm, 130 in-lbs).

There will be a little play in the driving shaft, but this is not a malfunction.

Main Switch (ON/OFF)

Push the upper half of the switch for forward rotation, or the lower half for reverse rotation.

Forward

Forward

Reverse

Reverse

	Speed selection		Torque
LOW		200 /min (rpm)	High
HIGH		600 /min (rpm)	Low

CAUTION:

•Check speed selector switch before use.

•Do not operate the speed selector switch while the main switch is on (switch is in the ON position).

Main Switch Lock

After use, set the main switch lock at the lock position to prevent accidental operation.

Main switch lock Lock

Battery Pack (EY9L10)

CAUTION:

1.Remove the battery pack away from the tool.

2.Charge the battery pack using the battery charger.

3.After charging has been completed, remove the battery pack from the charger and connect it to the tool.

Disconnect the charger from the power source when not in use.

Speed Selector Switch

To suit the application of this tool, two different rotational speeds are avail- able. Depending upon use, either the high or low speed should be select- ed.

HIGHLOW

NOTE:

Use under extremely hot or cold conditions will reduce operating capacity per charge.

- -