Equipment, Scope of Delivery | Kompernass PEBH 1010 manual

QEquipment

1Tool holder (drill chuck)

2Rubber dust protection cap

3Locking / unlocking cap

4ON / OFF switch

5Locking button

6Wheel for speed pre-selection

7Clockwise / counter-clockwise switch

8Function selector switch

9Additional handgrip

10Metal bit stop

QScope of Delivery

1 Hammer drill

1 Additional handgrip

1 quick-action drill chuck (13 mm) with adapter (see Fig. A)

3 Drills (see Fig. B)

1 Flat chisel (see Fig. B)

1 Pointed chisel (see Fig. B)

1 Metal bit stop

1 Tin of lubricating grease

1 Carrying case

1 Operating instructions

1 „Guarantee and Service“ booklet

QTechnical Information

Rated power
consumption:	1010 W
Rated voltage:	230 V ~, 50 Hz
Idle-running speed:	n0 0 - 1.100 / min
Impact frequency:	0 - 5.800 / min
Impact energy:	2.2 joules
Drill hole diameter:	max. 13 mm for steel
	max. 32 mm for wood
	max. 26 mm for concrete
	max. 82 mm
	with compass saw
Protection class:	II / &

Noise and vibration data:

Values determined in accordance with EN 60745.

Introduction

The sound pressure level (A-weighted) of the device is typically 99,6 dB (A). Uncertainty K = 3 dB. The sound level while working can exceed 112,6 dB (A).

Wear ear protection!

The total vibration (vector sum of three directions) is calculated in accordance with EN 60745:

Hammer drilling
in concrete:	Vibration emission value
	ah= 13.462 m / s2,
	Uncertainty K = 1.5 m / s2
Chiselling:	Vibration emission value
	ah= 12.320 m / s2,
	Uncertainty K = 1.5 m / s2

Warning! The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices. Different uses of the device give rise to different vibra- tion levels and in many cases they may exceed the values given in these instructions. It is easy to underes- timate the vibration load if the electrical power tool is used regularly in particular circumstances.

Note: If you wish to make an accurate assessment of the vibration loads experienced during a particu- lar period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actual- ly in use. This can result in a much lower vibration load over the whole of the period of working.

PEBH 1010
~	1010 W	· n0 1.100 min
230 V 50 Hz ·	1010 W	· n0 1.100 min
		-1
Date of manufacture: 04-2008
KH 3162
Kompernaß GmbH · 44867 Bochum (Germany) · www.kompernass.com

GB/IE/CY