BM 2610957386
Operation
Nail Unloading
Always disconnect tool from air supply
!WARNING before removing nails from magazine. This avoids the risk of unintentional operation.
Do not disconnect air hose from the tool ! WARNING with finger on trigger or work contact
element depressed. The tool can fire when reconnected to air supply.
1. Disconnect air supply.
2. Push magazine latch and pull magazine to open position, see figure 3.
3. Grasp the rear of the nail strip and remove from magazine.
Depth of Drive Adjustment
The depth with which nails are driven into the work piece can be adjusted using the depth adjustment on the nose of the tool, figure 10.
Disconnect the tool from the air source ! WARNING before making adjustments. Such
precautionary safety measures reduce the risk or unintentional tool operation.
1. Disconnect tool from air supply.
2. Remove nails from tool as described in the “Nail Unloading” section of this manual.
3. Adjust tool driving depth:
• To reduce the nail depth, turn the adjustment knob counter clockwise, see figure 11.
• To drive the nail deeper, turn the adjustment knob clockwise, see figure 12.
4. Reload nails as described in the “Nail Loading” section of this manual.
5. Reconnect air supply
Know what is behind your work piece. ! WARNING Do not fire nails into walls or floors
without assuring the area on the opposite side is clear. A nail could travel through the work piece, striking someone.
FIG. 10
Depth
Adjustment
Knob
Work Contact
Element
FIG. 11
Too Deep | Flush |
Turn the adjustment knob counter clockwise.
FIG. 12
Too Shallow
Flush
Turn the adjustment knob clockwise.
10.