Bosch Power Tools BNS200-18 manual Accessories, No-Mar Pad, Compressor

BM 2610957386 04-09:BM BNS200-18 04-09 6/17/09 7:55 AM Page 13

Accessories

No-Mar Pad

The No-Mar Pad on the nose of the work contact element protects the work piece from the work contact element when the work piece contact is compressed during actuation. The pad can be removed and replaced, figure 15.

Disconnect the air supply from the tool ! WARNING and remove nail strips before removing

or replacing no-mar pads. Such precautionary safety measures reduce the risk or unintentional tool operation.

To remove the pad: Pull the no mar tip directly away from tool.

To replace the pad: Push the no mar tip on to the tool inserting the opening of the no mar tip on to the work contact element.

Storage area for the no-mar pad can be found on the rear of the magazine, figure 16.

FIG. 15

Work Contact

Element

No-Mar Pad

Compressor

A correctly sized compressor is critical for maximum tool

performance. Use the following calculation to determine the FIG. 16 required compressor size.

Compressor size (CFM) =	Air Consumption(CFM)
	60

x Shots per minute x Number of tools x 1.2

Air Consumption, one shot per second @ 100 psi: 1.8 CFM

No-Mar Pad

Storage

13.