INSTALLATION AND BREAK-IN PROCEDURES
Air Filter Installation
To install air filter:
Insert threaded end of the air filter assembly into elbow and tighten until snug.
Do not operate compressor without air filter assembly installed as this will cause damage to the compressor.
Break-In Procedures
Serious damage may result if the fol- lowing
The
A. New compressor is put into service.
B. Check valve is replaced
C. New pump is installed on tank.
1.Recheck compressor wiring. Make sure wires are secure at all terminal connections. Free all contacts of loose wire cuttings, etc.
2.Open the air outlet valve fully to permit air to escape and prevent air pressure
3.Position the fuse disconnect or circuit breaker to the ON position and, if equipped, turn the
4.Run the compressor for 30 minutes. Make sure the air outlet, or globe valve, is open and there is no tank
5.Check for excessive vibration and noise. Adjust air compressor belt guard as necessary to eliminate chatter.
6.Close the outlet valve and let air compressor pump up to
7.Check all air line fittings and connections/piping for air leaks by applying a soap solution. Correct as neces- sary. Even minor leaks can cause this air compressor to overwork, resulting in premature breakdown or inadequate performance.
Additional Regulators and
Controls
Since the air tank pressure is usually greater than that which is needed, a separate regulator is usually employed to control the air pressure ahead of any individual air driven device.
Separate air transformers that combine the functions of air regulation and moisture and dirt removal should be used where applicable.
Lubrication and Oil
Compressors are shipped without oil. A small amount of oil may be present in the pump upon receipt of the air compressor. This is due to plant testing and does not mean that the pump contains oil. Do not attempt to operate in order to check wiring or for any reason without first adding oil to the crankcase. Serious damage to the pump can result from even very limited use with- out oil. Fill crankcase with recommended oil before operating.
Remove the oil fill plug and fill the crankcase with recom- mended oil. Refer to the Service Instructions in this manual for the specific oil recommended for use in your compres- sor unit. Replace the oil fill plug. Always fill to middle of sight glass.