TROUBLESHOOTING GUIDE
|
|
|
|
|
PROBLEM | CAUSE | CORRECTION | ||
|
|
|
|
|
Motor overheating. | Too many motor starts per hour. | Consult Service Center. | ||
(Continued) |
|
|
| |
|
| Improper wiring gauge. | Check electrical hookup and installation data or con- | |
|
| Incorrect voltage. | sult electrician. | |
|
|
| NOTE | |
|
|
| ||
|
| Current style electric motors run relatively hot under normal operating | ||
|
| conditions, with reasonable compressor loading. This condition is normal | ||
|
| and no adjustment is necessary. | ||
|
| Under normal operating conditions, the motor amperage draw will not | ||
|
| exceed the nameplate amperage rating, plus the service factor, as it appears | ||
|
| on the electric motor. If a condition of sustained high amperage exists, refer | ||
|
| to service checks above and/or consult electrician. If cause cannot be isolated | ||
|
| by an electrician, consult with Service Center for additional assistance. | ||
|
|
|
|
|
Water in pump crankcase; oil | Humid operating conditions. | Relocate compressor outfit, or change oil frequently. | ||
appears milky in color. |
|
|
| |
|
| Unit not reaching proper operating | Consult Service Center. | |
|
| temperature because the compres- |
|
|
|
| sor runs infrequently and is oversized |
|
|
|
| for the air requirement. |
|
|
|
|
|
|
|
Liquid water or moisture in air | Condensation forms in air lines when | Install compressed air dryer sized for the flow and | ||
lines. | the warm compressed air coming | dryness level required. | ||
|
| from the air tank starts to cool down |
|
|
|
| as it travels through the air lines. |
|
|
|
|
|
|
|