Epson Hardware Included with the DW746 Woodworker’s Table Saw, For Future USE

English

d. Plastic and composition (like hardboard) materials maybe cut on your saw. However, since these are usually quite hard and slippery, the anti-kickback pawls may not stop a kickback. Therefore, be especially attentive to following proper set up and cutting procedures for ripping.

e.Use saw blade guard and splitter for every operation for which it can be used, including all through-sawing.

f.Push the workpiece past the saw blade prior to release.

g.NEVER rip a workpiece that is twisted or warped, or does not have a straight edge to guide along the fence.

h.Use featherboards when the anti-kickback device or the guard and splitter cannot be used.

i.NEVER sawing a large workpiece that cannot be controlled.

j.NEVER use the fence as a guide or length stop when crosscutting.

k.NEVER saw a workpiece with loose knots, flaws, nails or other foreign objects.

l.NEVER rip a workpiece shorter than 10" (254 mm).

Hardware Included with the DW746 Woodworker’s Table Saw

BOLT
10 MM X 35 MM	T50 TORX
(2 PIECES)	FLAT HEAD SCREW
	10 MM X 30 MM
	(4 PIECES)

5 mm

HEX

WRENCH

( 1 )

WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproduc- tive harm. Some examples of these chemicals are:

•lead from lead-based paints,

•crystalline silica from bricks and cement and other masonry products, and

•arsenic and chromium from chemically-treated lumber (CCA). Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well-ventilated area and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.

•Avoid prolonged contact with dust from power sanding, saw- ing, grinding, drilling and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes or lay on the skin may promote absorption of harmful chemicals.

WARNING: Use of this tool can generate and/or disburse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropri- ate for the dust exposure. Direct particles away from face and body. Always operate tool in well-ventilated area and provide for proper dust removal. Use dust collection system wherever possible.

SAVE THESE INSTRUCTIONS

FOR FUTURE USE

BOLT

10 MM X 25 MM

(8 PIECES)

CARRIAGE BOLT

8 MM X 20 MM

(4 PIECES)

FLAT WASHER

(14 PIECES)

10 MM LOCK WASHER

(14 PIECES)

M 10 NUT

16 mm HEX (8 PIECES)

M 8 NUT

13 MM HEX (4 PIECES)

8 MM LOCK WASHER

(4 PIECES)

WRENCH

HOOK

(1)

PARTS SHOWN ARE

FULL SIZE - EXTRA

FASTENERS MAY HAVE

BEEN INCLUDED

T50

TORX

WRENCH

(1)

4