Installation and Operator’s Manual | Page 38 of 63 |
|
G Y R
G Y R
reset, there could be a water seepage due to condensation that is causing a ground fault or there is some other insulation breakdown. Have the system inspected by qualified personnel.
If the signal cannot be reset, insulate AURORA on both Dc and Ac sides so as to reach a safe condition; then contact an authorized center for repairing the fault.
5)Malfunction-Fault Signal
Every time AURORA check system detects an operative malfunction or fault, the yellow LED comes on and a message showing the type of problem found appears on the LCD.
6)RS-485 Address Setting Signal
During installation, the yellow LED will flash until the address is confirmed. For further information about setting the address, refer to chapter 6.3.
5.4Messages and Error Codes
The system status is identified through message or error signals appearing on the LCD.
The tables below summarize the two types of signals that can be displayed.
MESSAGES identify the AURORA actual status; so they do not relate to faults and nothing has to be done. The message will disappear as soon as standard conditions are restored.
ERRORS identify a possible fault of the equipment or of the connected parts. The signal will disappear as soon as the causes are removed, except for the ground insulation fault. Usually, when an error signal appears, an action is needed. This action will be managed as much as possible by AURORA or, in case this is not possible, AURORA will supply all the necessary information to assist the person fixing the fault on the equipment or system.