Aurora Electronics PVI-3600-OUTD-UK-F-W manual Close the side panel

Installation and Operator’s Manual	Page 30 of 63
(PVI-3600-OUTD-UK-F-W Rev.: 1.0)

2)Install suitable watertight connectors to the AURORA enclosure

3)Terminate the wires labeled + and – in the same input section terminal blocks of AURORA Input 1.

4)Connect the cable + to the terminal block labeled +

5)Connect the cable – to the terminal block labeled –

6)Tighten the screw to a torque of 0.6Nm (5.3 in-lbs.)

7)Make the proper connections of the cables to the Wind Interface Box. The + wire must be connected to the positive terminal of the Wind Interface box, the – wire must be connected to the negative terminal of the Wind interface box.

8)Verify that all connections have been executed properly and all the screws are tight.

Step 7/7: Close the side panel

WARNING: Tighten side panel screws with a torque of 1.5 Nm (13.2 in-lbs) to ensure watertight sealing.