3.2
English
3.2Switch Box
The switch box is located in the heat pump. It can be swung out after removing the lower front cover and loosening the fastening screw located in the upper
The switch box contains the supply connection terminals as well the power contactors and the soft starter unit.
The power supply cable and control line are installed ready for use.
3.3Heat pump controller
ATTENTION!
Use the heat pump controller included in the scope of supply to operate the
The heat pump controller is a convenient electronic regulation and control device. It controls and monitors the entire heating system on the basis of the external temperature, including hot water preparation and safety systems.
The customer must install the external temperature sensor, which is included in the scope of supply of the heat pump control- ler together with the necessary fixing accessories.
4 Transport
ATTENTION!
When transporting the heat pump, care must be taken to ensure that it is not tilted more than 45° (in any direction).
Use a wooden pallet for transporting the heat pump to the final in- stallation location. The basic device can be transported with a lift truck, hand truck or by means of 3/4" pipes fed through the holes in the base plate or frame.
The enclosed operating instructions describe the function and use of the heat pump controller.
ATTENTION!
The heat pump and transport pallet are only joined by the packing film.
Before using the transport holes in the frame, it is necessary to remove the lower side panel assemblies. This is done by loosen- ing each of the two screws at the base and then withdrawing the panels by unhooking them from above. Rehang the panels by gently pushing them in an upwards direction.
Be careful not to damage any components when inserting the pipes through the frame.
Opening the cover
Closing the cover