Model SB1027 | M A I N T E N A N C E | For Machines Mfg. Since 8/09 |
Coolant Reservoir
BIOLOGICAL & POISON
HAZARD!
Use the correct personal protection equipment when handling cutting fluid. Follow federal, state, and fluid manufacturer requirements for proper disposal.
A small amount of coolant is lost during normal operation. Check the coolant reservoir regularly and fill it if necessary. We recommend changing the coolant every three months or sooner if it develops an unpleasant odor.
The coolant reservoir holds approximately five gallons (19 liters) of fluid.
Checking Coolant Level |
|
Tools Needed | Qty |
Hex Wrench 3mm | 1 |
Piece of Wire | 1 |
To check the coolant level:
1.DISCONNECT MILL FROM POWER!
2.Clean away debris and grime from the coolant drain screens on the base of the mill (see Figure 56), then insert a clean and dry piece of wire through one of the screens to check the level of the coolant.
Drain
Screens
Figure 56. Locations of the coolant drain screens.
Running the coolant pump without adequate coolant in the reservoir may permanently damage the coolant pump. This action is considered abusive and is not covered by the warranty.
3.If the level of coolant in the reservoir is less than 2", add more fluid through the screen to fill the tank.