ASSEMBLY
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE U N T I L T H E M A C H I N E I S C O M P L E T E LY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
ASSEMBLING TABLE
TO MACHINE
1.Locate table locking lever (shown disassembled) Fig. 4, M10 flat washer (B) and 4mm wrench (C).
2.Using the 4mm wrench (C) Fig. 4, supplied, remove screw (D) and spring (E) from handle (A) and remove handle from nut (G). Do not lose spring (E).
A
B
G
C
E
D
Fig. 4
3.Place table (H) Fig. 5, onto the band saw frame so that stud (J) Fig. 6, and keepers (K) protrude through the slot of trunnion (L) Fig. 7.
4.Open hinged door. (See section “OPENING AND
CLOSING DOOR”.)
H
Fig. 5
5.While pressing in on stud (M) Fig. 8 with a pencil, place an M10 flat washer (B) Fig. 7, onto stud and thread nut (G) onto stud as shown in Fig. 7.
L 
BG
Fig. 7 | 8 |
|
K
J
K
Fig. 6
M
Fig. 8