Craftsman 113.248510 owner manual Assembly and alignment, Nuts Support Bracke Leveling Foot

assembly and alignment

MODEL 113.248210, 113.248320, 113.248440

ATTACHING LEVELING FEET

From the loose parts bag find the following hardware:

Item	Description	Qty.
A	Support Bracket	4
B	Leveling Feet	4
C	Hex Nut 3/8-16	8

From the loose parts find the following items:

D Leg 4

1.Mount floor leveler support brackets inside legs. Line up the three tabs on brackets with slots on leg and tap into place. Make sure lip on bracket points up. Install the remaining three brackets the same way.

2.Put a hex nut on each of the leveling feet and screw it down towards the rubber foot.

_D

*NOT SHOWN TO SCALE

LEG

®

SUPPORTBRACKET

3.Put the leveling feet through the holes in the bottom of the floor leveler support bracket.

4.Put another hex nut on each of the leveling feet_.nd

hand tighten until they are next to the support bracket.

WARNING: After the legset has been attached to the basic saw assernbly, it will be necessary to adjust the leveling feet so the saw does not rock.

NUTS

SUPPORT BRACKE ___,,.,_,.

LEVELING FOOT

11