Craftsman 113.248510 owner manual Model 113.248440, Adjusting Bevel Lock Knob

MODEL 113.248440 & 113.248510

TILTING HEAD FOR BEVEL CUT

1, Unlock bevel lock by pulling outon knob located under the left front edge of the table,

2.Turn handwhee4 counter-clockwise to increase the tilt angle of the blade. The digital display will read out the angle of the blade to the table.

3.Lock the bevel lock by pushing in on knob until it is fully seated when desired bevel angle is reached.

BEVEL LOCK

HANDWHEf

ELECTRONIC DISPLAY

PANEL

ALL MODELS

ADJUSTING BEVEL LOCK KNOB

The bevel lock knob is factory adjusted and set, If after repeated use it becomes necessary to adjust:

1.Pull the bevel lock foward and bevel the band saw to 25 degrees.

2.Use a 9/16-inch wrench or socket to adjust the locking nut behind the band saw mdunting frame. Turn nut clockwise to tighten.

3.Recheck bevel lock knob and readjust if neces- LOCKNUT sa ry.

MOUNTING FRAME	BEVEL LOCK
F	• KNOB

HANDWHEEL

35