Craftsman 113.248510 Model 113.248210 only, Attaching the Handwheel, Mounting the Motor

ALL MODELS

ATTACHING THE HANDWHEEL

1.From loose parts bag find one (1) pan head screw 10-32 x 2 and one (1) hex nut. Install the hand- wheel. Reach inside the base to the back side of the bevel mechanism and put the nut in place. Hold the nut in place with a finger. Install the screw through the center of the handwheel and tighten with a phillips screwdriver.

2.Hold the handle and pull the red release button with your finger to close the handle.

MOUNTING THE MOTOR

1.Find the following parts:

ITEM		DESCRIPTION			QTY.
A	Motor				1
B	Spacer(I/40.D.	x %6)		...................	3
C	Flanged Locknut #10-32				4
D Wing Nut %6-18					1
E	Motor Pulleyw/Set		Screw
	(Model 113.248320,			113.248440,
	113.248510)				1
F	Belt Tension	Stud			1
G	Motor Pulleyw/Set		Screw
	(Model 113.248210)			..................	1
H	Poly "V" Belt				1
I Key 3/%Sq. x 1%6
	(Model 113.248320,			1!3.248440,
	113.248510)				1

2.Place the three (3) spacers onto the three motor studs as shown. Pay attention to where the oil plug is located. No spacer goes on the fourth motor stud.

MODEL 113.248210 ONLY

3.Install the motor pulley onto the motor shaft with the set screw boss toward the motor. Position the outer

face of the pulley 2 inches from the end shield of the motor and tighten the set screw against the flat side of the motor shaft using a 1/8-inch hex "E'wrench.

7

_T _-_

( i¸ '

1

F

*NOT SHOWN TO SCALE

- OIL PLUG

1

1

OIL PLUG

r

17