Craftsman 113.248510 owner manual Model 113.24821 O, Attaching LEG SET, Description Qty Truss Head

MODEL 113.24821 O, 113.248320,

1113.248440

ATTACHING LEG SET

From the loose parts bag find the following hardware:

Item	Description		Qty.
A	Truss Head	Bolts 1/4.20x 1/2	32
B	Lockwashers	External 1/4	32
C	Hex Nuts 1/4-20		32

From the loose parts find the following items:

D	Leg Channel	1
E	Legs (with attached support brackets	and
	leveling feet)	4
F	Lower Stiffeners	4

_*NOT SHOWN TO SCALE

		Switch
			=_ont
1. Lay a piece of cardboard on the floor to keep from	Side	,/_/_J_//_1 __.Front Leg				s Are
scratching the saw.
2. Position the basic saw assembly on the floor as
shown below. The back cabin et of the saw should be
laying flat on the floor. It may be necessary to have	t__._	t	_	_		Leg
someone help you lift the saw.
				Artac bed		Here
		J[	t_'/ \	Rear	Legs Are
		L_._/_Attached_		__	_	Here
				\ Floor

3.Mount the two front legs to the basic saw assembly using truss head bolts, Iockwashers, and nuts. Make sure that the four (4) holes in each corner of the saw line up with the four (4) holes in the top of each leg. At this time only put bolts through thesides

of the saw assembly notthe front. Onlyfinger tighten nuts.

4.Position the leg channel inside the legset as shown. Fasten the channel piece, leg, and saw together with two (2) truss headbolts on each side. The threaded section of the bolts should point towards the inside of the basic saw assembly. Put a lock- washer and hex nuton each bolt. Finger tighten nuts at this time.

SAW

BAS E

LEG

!

TRUSS

HEAD

SCREW

LOCKWASHER

Trusshead screw, Iockwasher, hex nut, and front channel piece.

12