Craftsman 113.248510 owner manual Mounting the SAW to the Cabinet, Ware

MODEL 113.248510

6.Secure rear of shelf to right side and left side panels

using (2) 1/4-20 x 1/2 truss head bolts and hex nuts. Hand tighten only.

7.Locate the right and left side spacers, the six (6) 1/4-20 x 1/2 truss head bolts, Iockwashers, and

hex nuts. Position the spacer inside the right and left side panels and fasten in the three holes as

illustrated. Tighten nuts using a 7/16-inch wrench or socket.

Locate four (4) leveling feet and eight (8) 3/8-16 hex nuts. Attach the leveling feet to bottom of

side panels in front and rear as illustrated. Hand tighten hex nuts.

WARNING: TO AVOID INJURY FROM UN-

EXPECTED SAW OR WORK MOVEMENT, LEVELING FEET MUST BE ADJUSTED SO THAT SAW DOES NOT ROCK.

g.To adjust leveling feet so the saw will sit properly:

a.Move saw to desired location.

b.With 9/16-inch wrench loosen bottom nut.

c.Back off top nut by hand.

d.Raise or lower foot by adjusting bottom nut using 9/16-inch wrench.

e.Snug top nut against inside of leg by hand.

f. Adjust all four feet as necessary then tighten all four bottom nuts using a 9/16-inch wrench.

MOUNTING THE SAW TO THE CABINET
1, From loose parts bag find the following hard-
ware:
ITEM	DESCRIPTION	QTY.
A	Truss Head Bolts 1/4-20 x 1/2	4
B	Lockwashers External 1/4	4
C	Hex Nuts 1/4-20	4

LOCKWASHER

NUT

I

©

SPACER

2©

1/'4-20 x 1!2 RIGHT SIDE PANEL

c©

t5