Craftsman 113.248510 owner manual Mounting Front, Turn front table over. Locate the two 2 latch

ALL MODELS

6.To insure the backup bearing is properly sup- porting the blade, push the bearing toward the blade until it almost touches it. Turn the upper wheel, by hand, checking the backup bearing to make sure it is not turning. If the bearing is turning the blade is too close. Move bearing

slightly away from blade and tighten set screw with 1/8" hex "L" wrench. Turn upper wheel and

recheck the bearing. Adjust again if necessary.

7.Repeat procedure for lower backup bearing.

8.Turn upper wheel by hand and check the blade guides and backup bearings to make sure they are adjusted correctly. Make any readjustments if necessary.

9.Install blade guard and tighten with phillips screw- driver. (See illustration, page 26.)

I----""°° I I

FRONTCOYER

10.Install the front cover. Rest top edge of cover on two latch springs along the top edge of back cover. Swing cover down into position, engaging the three other latch springs. Push the front cover into position on the back cover. Check that the lip on the front cover completely overlaps the lip on the rear cover.

SPRING

MOUNTING	THE FRONT	TABLE		_	1/4-20 x 5/8
				_	WASHER HEAD
1. Turn front table over. Locate the two (2) latch				_' _	SCREW
				_'-_'"_	ALIGNMENT
		,_
springs, two (2) alignment springs, and the four			,,	t	ATOS...NG
(4) 1/4-20	x 5/8 hex washer	head thread forming

screws.

2.Install the two latch springs on the front table as illustrated using a 3/8-inch wrench or socket.

Install the two alignment springs on the front table as illustrated using a 3!8-inch wrench or

socket. _ FRONT TABLE

3O