Craftsman 113.248510 owner manual Models 113.248440

MODELS 113.248320,

113.248440, and 113.248510

4.Locate the correct motor pulley (Model 113.248210 has a "one-step" pulley). Placethe shaft key intothe groove on the motor shaft. Align the groove in the pulley with the shaft key and install the motor pulley on the motor shaft with the setscrew boss toward the motor.

ALL MODELS

5.Place the Poly "V" belt into the motor mount as shown on the underside of the band saw.

6.Look atthe motor mount and find the slot that is nar-

rower than the other three. When mounting the motor, the motor stud without a spacer goes into this slot.

7.Carefully position the motor sothat the poly"V" belt is around the motor pulley and the four motor studs align with the slots in the motor mount.

8.Push motor studs through and install the flanged lock nuts to the three (3) motor studs with spacers. Start the flanged nuts by hand only at this time.

MOTOR MOUNT

NARROW

SLOT

MOTOR MOUNT

MOTOR MOUNT

9.Install the threaded stud through the hole in the

lower leg of the motor mount and over the motor stud as shown.

THREADED STUD

18