Craftsman 113.248510 owner manual Head Capscrew

3.Locate the two (2) oval point setscrews 1/4-20 x 1/2 and use an 1/8-inch hex "L" wrench to install in the two holes, as illustrated, but do not allow

the screws to extend beyond the underside of the table.

4.Locate thetwo(2)table latches,two(2)3/8 " long Phil- lips head self tapping screws, two (2)small washers, and one (1)large washer.

5.Place front table latch through slot on right side of bandsaw frame.

6.Tilt top of front table latch slightly forward and place large washer between bracket and bandsaw frame.

7.Place self tapping screw through small washer and attach to table latch. Do not completely tighten screw.

8.Attach left side table latch with self tapping screw and washer as shown.

9.Locate the table alignment key and the two (2) 1/4-20x I low head capscrews, Install the key under the rear table miter gage slot and install the two screws but do not tighten at this time.

_.//HEX"L"WRENCH

j-1/4-20X1/2
I //OVAL	POINT
fSETSCREW

FRONT TABLE

/_TABLELATCH

LARGE

WASHER ON RIGHT

SIDE ONLY

WASHER

\

I TABLE LATCH

PHILLIPS HEAD

SELF TAPPING

SCREW

BASE

PHILLIPS HEAD

SELFTAPPING

SCREW

ASSEMBLE WITH LATCH TO

HIGHEST ADJUSTING POSITION

I- 1/4-20 X 1

_J_ _ HEAD CAPSCREW

TABLE AL:GNMENT

KEY

31