DeWalt DWD450, DWD460K Bail Handle Fig, Side Handle Fig, Slip Clutch, CLUTCHTMDWD460

English

FIG. 3

I I

FORWARD REVERSE

SLIP CLUTCH

The DWD450 and DWD460 are each equipped with a slip clutch. The clutch is active when the low speed (1) is selected. When the bit or cutter bites into the workpiece, the clutch will slip and a ratcheting sound will be heard. Release the trigger. Continued clutching of the tool will reduce the life of this feature.

E-CLUTCHTM(DWD460)

The DWD460 is equipped with E-ClutchTM. This feature senses the motion of the tool and reduces the motor torque to a manageable level if necessary. The E-ClutchTMindicator (G) will illuminate to indicate status.

INDICATOR DIAGNOSIS		SOLUTION
OFF	Tool is functioning	Follow all warnings and
		instructions when
	normally
		operating the tool.
		With the tool properly
	E-ClutchTMhas been	supported, release trigger.
SOLID		The tool will function
	activated (ENGAGED)	normally when the trigger

is depressed again and the indicator light will go out

INDICATOR	DIAGNOSIS	SOLUTION
FLASHING	E-ClutchTMis	Take the tool to an
	malfunctioning	authorized DEWALT
	(SERVICE)	repair agent.

NOTE: If tool power is insufficient for normal drilling and LED does not flash take tool to authorized DEWALT repair center.

Bail Handle (Fig. 4)

A bail handle is provided for carrying the tool and for use as an additional handle. Assemble the bail handle in one of the positions shown in Figure 4. When changing the location of the bail handle from one position to the other, completely remove the two bail handle bolts

(E)securing it. Flip the handle over and reinstall.

FIG. 4

J E

Side Handle (Fig. 5)

WARNING: To reduce the risk of personal injury, always operate the tool with the side handle properly installed and tightened. Failure to do so may result in the side handle slipping during tool operation and subsequent loss of control. Hold tool with both hands to maximize control.

6