Grizzly G0634Z manual Calibrating Depth Scale, Pulley Alignment, To calibrate the depth scale

Calibrating Depth

Scale

The depth scale on the infeed table can be cali- brated or "zeroed" if it is not correct.

Tools Needed	Qty
Straightedge	1
Phillips Screwdriver	1
To calibrate the depth scale:

1.DISCONNECT THE JOINTER/PLANER FROM THE POWER SOURCE!

2.Set the outfeed table height as described in the Setting Outfeed Table Height instruc- tions on Page 18.

3.Use the straightedge to help adjust the infeed table exactly even with the outfeed table, as shown in Figure 65.

������������ ������� ������

Figure 65. Infeed table even with outfeed table.

4. Using a screwdriver, adjust the scale pointer to zero (Figure 66).

Figure 66. Depth scale adjusted to “0” position.

Pulley Alignment

Tools Needed:	Qty
Straightedge	1
Hex Wrench 3mm	1
C-Clamps	2
Proper pulley alignment (see Figure 68) prevents
premature belt wear. The pulleys are properly
aligned when they are parallel and in the same
plane as each other.
To align the pulleys:

1.Remove the fence assembly, fence bracket, and the V-belt cover (Figure 67).

Figure 67. Fence and V-belt cover removed.

2.Place a 2" C-clamp on each pulley so the adjustment shaft faces out, place a straight- edge on the clamps, as shown in Figure 68, and visually check pulley alignment.

Figure 68. Checking belt alignment.

-46- G0633/G0634 Jointer/Planer Combo Machine