Grizzly G0634Z manual Adjusting Table Lock Levers, To set the 45 fence stop

To set the 45° fence stop:

1.Loosen the fence tilt lock, and position the fence against the 45° stop bolt.

2.Loosen the lock nut on the 45˚ fence stop bolt (Figure 71).

45° Stop Bolt

Lock Nut

Figure 71. Adjusting fence 45˚ outward.

3.Adjust the 45˚ stop bolt until the fence is exactly 45° outward while resting on the bolt (check the angle with a sliding bevel set to 135° or with a 45° square.

4.Retighten the lock nut loosened in Step 2.

-48-

Adjusting Table Lock

Levers

The table lock levers can be adjusted if they do not lock.

Tools Needed	Qty
Wrench 14 mm	1
To adjust the table lock levers:

1.DISCONNECT THE JOINTER/PLANER FROM THE POWER SOURCE!

2.Remove the cutterhead guard.

3.Raise the table on the side of the lock lever that does not lock.

4.Loosen the lock nut on the special bolt under the table, as shown in Figure 72.

Special

Bolt

Lock Nut

Figure 72. Table lock lever bolt.

5.Adjust the bolt height a few turns, lower the table, and try engaging the lock lever.

6.Repeat Steps 3-5until the lever engages, then secure the lock nut.

G0633/G0634 Jointer/Planer Combo Machine