Grizzly G0634Z manual Basic Planer Controls, Jointer-Planer Conversion

Basic Planer

Controls

This section covers the basic controls used during routine planer operations.

See Page 22 for a description of START/STOP/ EMERGENCY OFF buttons.

Table Height Handwheel: To move the planer table, rotate the table height handwheel (Figure 22).

Table Lock Lever: Turn the lever clockwise to prevent the table moving during planer opera- tions; loosen to move the table handwheel.

Table Height Scale: Read depth-of-cut from the inch/millimeter scale.

Change Lever: When the lever is in the "up" posi- tion this converts the machine to planer opera- tions.

	Table Height
	Scale
Change	Table Lock	Table Height
Lever
	Lever	Handwheel

Figure 22. Planer table control locations.

Jointer-Planer

Conversion

The Model G0633/G0634 is ready for jointer operations after it is setup. To use the machine as a planer, you must perform a conversion.

To set up the machine for planer operations:

1.DISCONNECT THE JOINTER/PLANER FROM THE POWER SOURCE!

2.Remove the cutterhead guard.

3.Loosen the quick release knobs (Figure 23) and slide the fence off the machine.

Quick Release

Knobs

Figure 23. Fence removal.

4.Remove the dust hose from the jointer dust port.

-24- G0633/G0634 Jointer/Planer Combo Machine