Table Movement: Loosen the cap screws on the infeed handgrip and outfeed table adjustment knob before moving the infeed and outfeed tables (Figure 19). Use an adjustable wrench to turn the outfeed adjustment knob.
Cap Screw |
| Cap |
|
| Screw |
|
|
|
Outfeed Table |
| Infeed |
Adj. Knob |
| Handgrip |
|
|
|
Figure 19. Table control locations.
Fence Movement: The fence lock keeps the fence in position (Figure 20). To move the fence, loosen the lock and turn the fence adjustment knob to move it as needed.
Fence Adj. | Fence |
Knob | Lock |
| Tilt |
| Lock |
Figure 20. Fence lock location.
Fence Tilting: The tilt lock (Figure 20) secures the fence at any position in the available range. Fence stops set the fence at 90° or 45° outward. The tilt lock must be tightened before cutting. See Page 47 for more detail on adjusting the fence stops.
To move the fence to 45° outward, loosen the tilt lock and fence height knobs, move the fence flush against the table (see Figure 21), and tighten the height knobs and tilt lock. Verify the angle with a 45° square. To return the fence to the 90° posi- tion, loosen the tilt lock and height knobs, raise the fence to 90°, and tighten the height knobs and tilt lock. Check the fence angle with a 90° square, and make sure the fence and table are flush.
Fence Height Knobs
Figure 21. Fence flush with table at 45°.
G0633/G0634 Jointer/Planer Combo Machine |