English
SPECIFICATIONS
Voltage (by areas)* | (110V, 115V, 120V, 127V, 220V, 230V, 240V) |
Power input | 950 W* |
Capacity | Drill bit: 40 mm |
| Core bit: 105 mm |
No load speed | 360/min. |
2800/min. | |
Weight (without cord, side handle) | 6.7 kg |
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES |
| |
(1) | Case (Molded plastic) | 1 |
(2) | Side Handle | 1 |
(3) | Stopper | 1 |
(4) | Hexagon Bar Wrench (for 6 mm screw) | 1 |
(5) | Hexagon Bar Wrench (for 5 mm screw) | 1 |
(6) | Hammer Grease A | 1 |
(7) | Dust Cover | 1 |
Standard accessories are subject to change without | ||
notice. |
| |
OPTIONAL ACCESSORIES (sold separately)
1.
(1)Drill bit (spline shank) Overall length: 400 mm External dia.: 12.7, 25.4, 38.1 mm
2.Anchor hole drilling (Rotation + Hammering)
(3)Cotter
(1) Drill | bit (taper | shank) |
| (2) Taper shank | |
|
|
|
|
| adapter |
|
|
|
|
| (Spline shank) |
|
|
|
|
| |
Taper | shank |
| Application | drill bit | |
adapter |
|
|
|
| |
| Taper shank adapter formed A- | ||||
|
|
| taper or | ||
| optional | accessory, but drill bit | |||
| for it is | not | provided. | ||
|
|
| |||
3. Large dia. hole boring (Rotation + Hammering)
(Guide | (1) Center | (2) Core | (3) Core | bit |
plate) | pin | bit | shank | |
|
|
| (Spline | shank) |
(1) Center pin
⬤Applied to core bits from 38 mm to 105 mm
(2) Core bit
⬤External dia. 50, 105 mm (with guide plate)
(3) Core bit shank
⬤Applied to core bits above 38 mm
4.Crushing (Hammering)
(1)Bull point
Overall length: 300 mm
5. Groove digging and edging (Hammering)
(1) Cold chisel
Overall length: 300, 460 mm
6.Asphalt cutting (Hammering)
(1)Cutter
7.Syringe (for chip removal)
8.Hammer grease A 500 g (in a can)
70 g (in a green tube)
30 g (in a green tube)
Optional accessories are subject to change without notice.
APPLICATIONS
◯Drilling holes in concrete
◯Drilling anchor holes
◯Crushing concrete, chipping, digging, and squaring (by applying optional accessories)
PRIOR TO OPERATION
1.Power source
Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate.
6