BM 1609929T61 07-09:BM 1609929T61 07-09 7/8/09 1:37 PM Page 10
TYPE 27, 28 & 29 GRINDING
WHEEL ASSEMBLY Disconnect tool from power source. Be sure that wheel guard is in place for grinding.
When using mounting wheels, thread BACKING FLANGE all the way down onto spindle, then place GRINDING WHEEL on the spindle. Thread on the lock nut and tighten nut using a lock nut wrench provided with flange kit, while holding the spindle lock in (Fig. 3).
TO REMOVE: Reverse procedure.
When using
ABRASIVE TYPE 1A & 27A
WHEEL ASSEMBLY
Using the optional type 1A wheel guard, it is possible to perform limited cutting on small stock such as metal tubes, piping or rebar.
Do not attempt to cut large stock or sheets of metal as this tool is not designed to be a dedicated cutting tool.
| Always use type 1A protection | |
! WARNING | ||
guard for cutting. |
Disconnect tool from power source. Be sure that wheel guard is in place for cutting.
When using mounting wheels, thread BACKING FLANGE all the way down onto spindle, then place GRINDING WHEEL on the spindle. Thread on the lock nut and tighten nut using a lock nut wrench provided with flange kit, while holding the spindle lock in (Fig. 4).
TO REMOVE: Reverse procedure.
TYPE 1 ABRASIVE
STRAIGHT GRINDING WHEELS
Do not use type 1 abrasive ! WARNING wheels designed for
straight/die grinding. This tool is not designed for use with type 1 abrasive straight/die grinding wheels.
FIG. 3
SPINDLE
TYPE 27
SPIN-ON
GRINDING
WHEEL
FIG. 4
|
| SPINDLE |
|
| TYPE 1A |
|
| WHEEL GUARD |
TYPE 27 |
|
|
WHEEL GUARD |
|
|
BACKING |
| BACKING |
FLANGE |
| FLANGE |
TYPE 27 |
|
|
GRINDING |
|
|
WHEEL |
| LOCK NUT |
|
| |
LOCK NUT | TYPE 1A | TYPE 27A |
WHEEL | WHEEL |
|