Page 35
Chapter 1 Preparing for Installation
Cisco ASR 9001 Router Port Connection Guidelines
Table 1-5 | RP Management LAN Port Signals (continued) |
| | |
MGT LAN Port Pin | 10Base-T, 100Base-TX Signal | 1000Base-T Signal |
| | | |
| 4 | — | BI_DC+ |
| | | |
| 5 | — | BI_DC– |
| | | |
| 6 | Receive– | BI_DB– |
| | | |
| 7 | — | BI_DD+ |
| | | |
| 8 | — | BI_DD– |
| | | |
Management LAN Port LED Indicators
The Management LAN connectors have integral LED indicators (see Figure 1-24). When lit, these LEDs indicate:
•Green (LINK)—Connection is alive.
•Amber (ACT)—Connection is active.
Figure 1-24 RP Management LAN Port LED Indicators
332427
Management LAN RJ-45 Cabling
When connecting the RJ-45 port to a hub, repeater, or switch, use the straight-through cable pinout shown in Figure 1-25.
Note To comply with the intra-building lightning surge requirements of Telecordia GR-1089-CORE, Issue II, Revision 01, February 1999, you must use a shielded cable when connecting the management LAN ports on the RP card. The shielded cable is terminated by shielded connectors on both ends, with the cable shield material tied to both connectors.
| | Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide | | |
| | |
| OL-26701-02 | | | 1-25 | |
| | | |
