Cisco Systems ASR9001s, 9001S manual Table A-3 Cisco ASR 9001 AC Electrical Specifications

Appendix A Technical Specifications

Table A-3lists the AC electrical specifications for the Cisco ASR 9001 Router.

Table A-3	Cisco ASR 9001 AC Electrical Specifications
Description		Value
Power modules per system		Up to two AC power modules per system
Total AC input power		765 VA (volt-amps) per AC power supply
		(up to two AC power supply modules per system)
Rated input voltage1		100–240 VAC nominal (range: 90 to 264 VAC)
		220–240 VAC (UK)
Rated input line frequency1		50/60 Hz nominal (range: 47 to 63 Hz)
		50/60 Hz (UK)
Input current rating1		15 A maximum at 100 VAC
		13 A maximum at 220 to 240 VRMS (UK)
Source AC service		15 A North America and Japan; 10 A international; 13 A UK
requirement1
Redundancy		Power redundancy requirements vary, based on system configuration
		(number and type of line cards, etc). AC powered systems are 2N
		protected and DC powered systems are N+1 protected.

1. For each AC power supply module.

Caution Be sure that the chassis configuration complies with the required power budgets. Failure to properly verify the configuration may result in an unpredictable state if one of the power units fails. Contact your local sales representative for assistance.

Table A-4lists the DC electrical specifications for the Cisco ASR 9001 Router.

Table A-4 Cisco ASR 9001 DC Electrical Specifications

Description	Value
Power modules per system	Up to two DC power modules per system
Total DC input power per	750 W
power module
Rated input voltage per	–48 VDC nominal in North America
power module	–60 VDC nominal in the European Community
	(range: –40.5 to –72 VDC [–75 VDC for 5 ms])
Input current rating1	15 A maximum at –48 VDC nominal
	15 A maximum at –60 VDC nominal
Source DC service	Sufficient to supply the rated input current. Local codes apply.
requirement1
Redundancy	Power redundancy requirements vary, based on system configuration
	(number and type of line cards, etc). AC powered systems are 2N
	protected and DC powered systems are N+1 protected.

1.For each DC power supply module. Some power/chassis configurations may operate at lower current ratings than those specified in this table. Contact your Cisco technical representative for more information.

Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide

OL-26701-02 A-3