Chapter 3 Installing Modules and Cables in the Chassis
Connecting Power to the Router
Connecting Power to a DC-Powered Router
This section contains the procedures to connect the DC source power cables to a
The color coding of source DC power cable leads depends on the color coding of the site DC power source. Because there is no color code standard for source DC wiring, you must be sure that power source cables are connected to the power module with the proper positive (+) and negative
•In some cases, the source DC cable leads might have a positive (+) or a negative
•Green (or green and yellow) cable typically indicates that it is a ground cable.
Caution DC power modules contain circuitry to trip the breaker on the power module if the power module detects a reverse polarity condition. No damage would occur from reverse polarity, but you should correct a
Note The length of the cables depends on the location of your router in relation to the source of DC power. These cables are not available from Cisco Systems. They are available from external commercial cable vendors. For more information on site power and source DC cable requirements, see the “Power Connection Guidelines” section on page
Note To ensure that power remains off while you are performing this procedure, tape the DC circuit breaker switch in the off (0) position.
Use this procedure to connect the DC source power cables to a DC power module:
Step 1 Verify that the power switch is set to the OFF position.
Step 2 Connect the DC power cables in the following order (see Figure
a.Ground cables first.
b.Positive cables next.
c.Negative cable last.
Step 3 Repeat Step 2 for the other power modules installed in the chassis.
Warning To prevent injury and damage to the equipment, always attach the ground and source DC power cable to power module terminals in the following order: (1) ground to ground, (2) positive (+) to positive (+),
(3) negative (–) to negative (–).
| Cisco ASR 9001 and Cisco ASR |
|