Bosch Power Tools PR20EVSNK, PR10E Base, Cut, Templet Guides, Templet Guide Adapter Release Lever

BM 2610021461 06-12_BM 2610021461 06-12.qxp 6/26/12 1:38 PM Page 25

FIG. 44		FEED
		DIRECTION
BASE
		M6 WING SCREW
		FINE
	CUT	ADJUSTMENT
		INDICATOR
		ROUTER
	DESIRED	GUIDE RODS
WORKPIECE		FINE ADJUSTMENT
	WIDTH
		KNOB

TEMPLET GUIDES

This plunge base can also be used with the optional Bosch-exclusive quick-change templet guide system, which firmly grips the guides with a spring-loaded ring. Unlike conventional threaded templet guides, there is no threaded ring that can come loose while routing. (Fig. 45)

TEMPLET GUIDE

ADAPTER

FIG. 45

TEMPLET GUIDE

RELEASE LEVER

TEMPLET GUIDE (optional accessory)

CENTERING THE SUB-BASE OR

TEMPLET GUIDES

Your PR011 plunge base features the Bosch “Precision Centering Design”. Its subbase is precisely centered at the factory. This positions the bit at the center of the subbase and optional templet guides.

Precision centering allows you to use the edge of the subbase or templet guides to closely follow jigs such as straight guides, templets, and dovetail fixtures without worrying about bit walk-off from the intended cut line for any reason, including the orientation of the router’s handles relative to the jig.

To most precisely re-center the subbase or templet guides, attach the subbase using the optional Bosch RA1151 Centering Device. Follow steps 1-8 (Fig. 47).

INSTALLING TEMPLET GUIDE ADAPTER (Not included, available as accessory)

Place templet guide adapter over the holes in the center of the sub-base, and align the two threaded holes in the bottom of adapter with the countersunk holes in subbase. Fasten adapter with the screws provided. Note that the adapter is reversible, so the release lever may be positioned as desired. (Fig. 46)

FIG. 46

TEMPLET GUIDE

ADAPTER

(optional accessory)

MOUNTING SCREWS

1.If a templet guide is to be centered, Install the templet guide adapter and template guide (optional attachments) as described elsewhere in this manual.

2.Loosen the four screws that hold the subbase to the base.

3.Prepare the Centering Device:

•Use narrow end of steel shaft.

•When centering subbase or templet guide that has opening of more than ½”, slide the wide plastic sleeve over the steel shaft.

4.Slide centering sleeve through the subbase or templet guide and into collet. Tighten collet nut with fingers to put slight grip on centering cone.

-25-