
BM 2610021461 06-12_BM 2610021461 06-12.qxp 6/26/12 1:38 PM Page 17
PR004 OFFSET BASE
(Included with PR20EVSNK. Also available as
optional accessory)
The PR004 Offset Base is designed for routing in confined areas, especially for trimming laminates in areas that are inaccessible with the standard fixed base, such as locations that are close to adjacent vertical surfaces like as the tops of
The PR004 allows routing extremely close to vertical surface in front of the tool, as close as 1/2” when 3/4” bit is used (Removal of the black offset spindle cover further reduces distance from 3/4” bit and vertical surface to 3/8”.) The
The PR004 can also be used to scribe the back of a new counter backsplash so that it will mate precisely with the wall against which it will rest (Fig. 24).
Heat Build-Up
To reduce the risk of injury, ! WARNING do not use the offset base
for more than 10 minutes continuously.
Prolonged continuous use will result in the tool becoming hot to the touch.
The nature of a belt drive mechanism like the one in the PR004 Offset Base creates more heat than when the motor is used in its other bases. To help minimize heat
Motor Installation
1.Remove collet from motor and install toothed drive pulley using collet wrench. Make sure that drive gear is fully tightened onto the motor’s spindle. (Fig. 25)
2.The motor is then installed into the base according to the instructions on page 9.
3.Insert screwdriver (not included) through the
FIG. 25
DRIVE GEAR
FIG. 23
FIG. 24
FIG. 26