BM2610995777 10/03 10/7/03 4:51 PM Page 17
Preparation For Use With Bosch Router Table
Your router is uniquely suited for use in the Bosch router table. For detailed instructions about router table procedures, please refer to the manual that is supplied with the router table. To prepare the 1619EVS for table mounting, do the following:
HOUSING | FIG. 22 |
PLUNGE LOCK
OVERRIDE LEVER
PLUNGE
LOCK LEVER
1.Engage plunge lock override lever as follows: Facing the rear of the router, move plunge lock lever approximately 90 degrees clockwise. Depress small override lever and slowly release plunge lock lever until override lever catches firmly on metal housing as shown in diagram. The motor is now free to move up and down on the posts (Fig. 22).
COARSE
ADJUSTMENT
LOCK
FIG. 23
SPRING
DEFEAT BUTTON
2.Engage the plunge return spring defeat (Fig. 23).
Note: This unique feature makes it easier to adjust the height of the bit when the router is mounted under a router table.
a. Move the depth rod to its highest position, and lock in place with coarse adjustment lock.
b. Remove the collet chuck.
c. Rotate depth stop turret to the position shown in Fig. 23.
d. Plunge the router motor down as far as it will go.
e. While holding the motor down, press and hold down spring defeat button.
f.Allow the motor to move up slightly.
g.Release the button.
The plunge return spring pressure is now disengaged.
FIG. 24
DEPTH ROD
SPRING DEFEAT
BUTTON
KEYHOLE
DEPTH STOP
TURRET
3.Connect the depth rod to the depth stop turret by rotating the depth stop turret so that the large end of keyhole slot is aligned with the lower end of the depth rod. Release coarse adjust lock, and lower depth rod into the large end of keyhole slot. Rotate depth stop turret until the smaller end of the keyhole traps the end of depth rod (Fig. 24). (To keep the rod in the keyhole, there is a raised rim around the underside of the smaller end of the keyhole. When inverted, the weight of the router keeps the depth rod inside the raised rim.) Note: When the router motor is at its further point away from the base, the motor must be moved slightly closer to the base so the depth rod can clear the raised rim.