Fine sanding - eccentric motion
This position is selected for sanding with low output for a
Triangular sanding and pad change - Fig. [4]
3
This position is used for sanding with the delta sanding pad and slat sanding pad; the rotary motion is blocked.
You can change the sanding pad in this position.
The stop rod
Changing sanding/polishing pad -
Fig. [5]
Only use sanding and polishing pads that are suitable for the maximum speed speci- fied.
3
Tuned to the surface being processed, the machine can be equipped with two sanding pads of different hardnesses.
Hard: Coarse and fine sanding on surfaces. Sanding edges.
Soft: Universal for coarse and fine sanding, for flat and convex surfaces.
When the interface pad
XFollowing the sanding pad change, switch the
Changing sanding pad - Fig. [6]
The delta sanding pad
11