Teledyne powerpod 400 instruction manual Table of Contents

Table of Contents

1.0	QUICK START INSTRUCTIONS		5
2.0	SAFETY		6
3.0	FEATURES		7
4.0	SPECIFICATIONS		9
5.0	FRONT PANEL		10
6.0	REAR PANEL		11
7.0	WIRING		12
7.1.		POWER	12
7.2.		COMMUNICATIONS	12
7.3.		TRANSDUCER CONNECTIONS	13
7.4.		ALARMS	13
7.5.		ANALOG SIGNAL FOLLOWERS	14
8.0	MANUAL OPERATION		15
8.1.		POWER ON/OFF	15
8.2.		CHANGING THE COMMAND SET POINT	15
8.3.		OVERRIDE OPEN	15
8.4.		OVERRIDE CLOSED	15
8.5.		SETTING A CHANNEL TO AUTO CONTROL	16
8.6.		SETTING A CHANNEL TO DIRECTLY METER INCOMING SIGNALS	16
8.7.		SETTING A CHANNEL TO DISPLAY THE TOTALIZER FUNCTION	16
9.0	EXTERNAL/REMOTE OPERATION		18
9.1.		SELECTING EXTERNAL/REMOTE OPERATION (FRONT PANEL ONLY)	18
9.2.		CHOOSING RS-232 COMMUNICATION	18
9.3.		CHOOSING RS-485 COMMUNICATION	18
10.0	SETUP/CAL MODE		19
10.1.		ENTERING THE SETUP/CAL MODE	19
10.2.		DISPLAY SETUP	19
10.2.1.		BLANKING A DISPLAY LINE/CHANNEL	19
10.2.2.		SELECTING DISPLAY BRIGHTNESS	19
10.2.3.		SELECTING UNIT-OF-MEASURE	20
10.2.4.		SELECTING GAS ID	20
10.2.5.		SETTING A/D CONVERSION RATE (FILTER)	20
10.2.6.		FRONT PANEL LOCK OUT	21
10.3.		TOTALIZER SETUP	21
10.3.1.		COUNT UP TO A SET POINT	21
10.3.2.		COUNT DOWN FROM A SET POINT	22
10.3.3.		COUNT CONTINUOUSLY	22
10.4.		EXTERNAL COMMUNICATION SETUP	22
10.4.1.		RS-232 SETTINGS	22
10.4.2.		RS-485 SETTINGS	22
10.5.		SELECTING THE ANALOG SIGNAL LEVEL	23

10.5.1. ZERO TO FIVE VOLT OPERATION	................................................................................................................. 23
10.5.2. ZERO TO TEN VOLT OPERATION	................................................................................................................. 23
164-122012 PowerPOD 400	Page 3 of 42