Sharp KC-840E, KC-860E, KC-850E operation manual Humidifying Tray, Rinse the Humidifying, Impurities

HUMIDIFYING TRAY

		Frequency of maintenance cycle will depend on the hardness
Care Cycle	1 month
		of the water. Avoid spilling water when removing or cleaning
		the tray.

1	Remove the Water Tank and Humidifying				When Water Deposits are Difficult to Remove
	Tray.
				Tank Handle 1		Fill Humidifying Tray half-
	Unlatch the Water
	Tank first, then re-					way with lukewarm water,
	move the tray. Use					add a small amount of mild
	both hands when					kitchen detergent, and leave
	pulling out the Hu-			Water Tank		to soak for about 30 min-
	midifying Tray	to				utes.
	avoid spilling water.
2	Remove the Humidifying Filter from the					Dilute detergent according to
						instructions on the container.
	Humidifying Tray. Drain accumulated wa-					Clean difficult-to-reach parts
	ter by tilting the Humidifying Tray slowly.					with a cotton
						swab or tooth
				Do not hold		brush.
				this part.
Humidifying Filter				Humidifying
				Tray	2	Rinse the Humidifying
3	Rinse the inside of the Humidifying					Tray with lukewarm wa-
						ter.
	Tray with lukewarm water to remove					• Rinse until all detergent residue
	impurities.
	• Do not remove the					is removed.
			Float			• Inadequate rinsing may
	Styrofoam float.					cause the de-
	• Clean difficult-to-
						tergent odour
	reach parts with a
						or changes
	cotton-tipped swab
	or tooth brush.					in the shape/
						colour of the
4	Replace the Humidifying Filter and re-					main unit.
	place the Humidifying Tray in the unit.
	The Humidifying Filter will not			Colour: Gray		CAUTION
	fit if placed in backwards. Be
	sure there is no gap between					• Use only mild kitchen detergents to
	the Humidifying tray and the					clean the Humidifying Tray. Use of
	unit when the Humidifying Tray					non-designated chemicals or deter-
	is replaced in the unit. The unit					gents can cause deformation, tar-
	may not operate properly if the					nishing, cracking (water leakage).
	Humidifying Tray is not prop-
	erly replaced in the unit.
If the Styrofoam float comes off,						Insert the float below
replace by inserting the tabs of						this tab.
the Float into the holes in the
Humidifying Tray as shown in the						Insert the tab on
diagram.			Insert the tab of the
						the other side of the
			float into the hole.			float into the hole.

РУССКИЙ NEDERLANDS FRANÇAIS DEUTSCH ENGLISH

E-13