HP R-2 RDR, R-2A RPC-2 MD01 and RPC-2 RDR, Local Access, Using the EIA-232, Serial Connection

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

RPC-2 MD01 AND RPC-2 RDR

LOCAL ACCESS	The RPC-2 MD01 and RPC-2 RDR have an
USING THE EIA-232	RJ-45 port for connecting to a local EIA-232
SERIAL CONNECTION	device, such as a computer terminal or
	external modem. Most serial computers do
	not have RJ-45 connections; therefore, an
	adapter is provided with this unit to convert
	from a DE-9 connector to an RJ-45
	connector (BayTech Part No. 9FRJ45PC-1).
	If you are connecting to a modem, use a
	modem adapter (BayTech Part No.
	25MRJ45MD-8).
	BayTech also manufactures a
	computer/terminal adapter (BayTech Part
	No. 25FRJ45PC-1) for converting from a
	DB-25 connector to an RJ-45 connector. If
	your computer does have an RJ-45
	connection, but the pin signals are different
	from those described for BayTech on Page
	16 of this manual, it is possible for BayTech
	to customize an adapter for you. If you
	require a different adapter than the one
	supplied with this unit, contact one of
	BayTech’s Applications Engineers.
	Using the 9FRJ45PC-1 adapter (or other
	applicable adapter) and the RJ08X007
	crossed cable, connect the serial port of your
	computer to the RJ-45 port labeled “EIA-
	232” on the back of your RPC unit.
	Load serial port communications software.
	Configure host terminal’s serial
	communications parameters to match the
	RPC. RPC factory serial communications

27