HP R-2 MD01, R-2A, R-3A, R-2 RDR manual Default Unit ID is RPC-3, Access

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

Enter the Gateway address (Example: 200.4.5.50), followed by <cr>. The RPC resumes the configuration menu Default Gateway address is 0.0.0.0. If you fail to enter the Gateway address is dotted decimal form, the RPC responds again:

	Enter Gateway address in dotted decimal form:
	The RPC responds indefinitely with the
	same request until the Gateway address is
	entered in the correct form.
Unit ID	From the configuration menu, select #4,
	“Unit ID.” The RPC responds:
	Enter Unit ID (64 chars max):
	Enter the RPC Unit ID, followed <cr>. The
	RPC resumes the configuration menu.
	Default Unit ID is RPC-3.
Access	Login Setup allows the user to enable or
	disable username and password login for
	both serial and network ports. If the features
	are enabled, the RPC requires username and
	password entry before allowing access to the
	unit.
	To configure the login setup, select #5,
	“Access,” from the configuration menu,
	followed by <cr>. The RPC Series responds
	with the following Login Setup menu:

49