HP R-2 RDR, R-2A, R-3A Configuration can be performed by, Admin user only via the serial port or

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

CONFIGURATION	Configuration can be performed by the
	admin user only via the serial port or the
	network port. From the RPC Main Menu,
	select #3, “Configuration.” The following
	menu appears:
	Bay Technical Associates
	RPC-3 Configuration Menu
	MAC Addr:	00.C0.48.05.53.A2
	Unit ID: RPC3
	Medium Stat:	good
	Active users:	1

Enter choice from menu, CR to exit

1)	. . . IP Address	:	0.0.0.0
2)	. . . Subnet Mask	:	0.0.0.0
3)	. . . Gateway	:	0.0.0.0
4)	. . . Unit ID	:	RPC-3

5). . . Access

6). . . Outlets

7). . . Exit

IMPORTANT: Network parameters, such as IP Address, require a Unit Reset before any changes will take affect. Other configuration changes will be immediately implemented upon accepting changes at the end of the configuration procedure. Exit all menus by pressing <cr>.

IP Address	The IP Address consists of four bytes, each
	byte ranging from 0 to 255. This parameter
	must be programmed before the RPC can be
	accessed on the network.
	From the configuration menu, select #1, “IP
	Address.” The RPC responds:
	Enter IP address in dotted decimal form:
	Enter the IP Address (Example:
	200.4.3.50), followed by a carriage return.
	Upon entry of a carriage return, the RPC
	resumes the configuration menu. Default IP

47