![](/images/new-backgrounds/1213258/21325857x1.webp)
RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
(c)1997 by BayTech
F2.07
Circuit Breaker : On
1) . . . OUTLET 1 | : Off |
2) . . . OUTLET 2 | : Off |
3) . . . OUTLET 3 | : On |
4) . . . OUTLET 4 | : Off |
5) . . . OUTLET 5 | : Off |
6) . . . OUTLET 6 | : Off |
RPC > |
|
Likewise, typing ON 0 at the RPC > prompt and responding “Y” for yes, turns “On” all outlets. Typing OFF n at the RPC > prompt turns off corresponding outlet(s).
The REBOOT n command will reboot or reset equipment attached to corresponding receptacle(s). When the command to REBOOT (n) is sent from the RPC > prompt, the RPC powers “Off” corresponding outlet(s) for approximately 10 seconds, then powers them up in sequence. This command only works on outlets which were “On” prior to the reboot.
CONFIGURATION The
The password is disabled from the factory by making the password a carriage return. If a password (other than a carriage return) is
22